UseColors yesno parcp's native colors are white on blue, just like Norton Commander.
Parcp is also much faster than its competitors, runs under more operating systems, it's simpler to use and supports multitasking.
Machines with 32-bit x86 CPU).
If the parallel port was detected as unidirectional, and you would like to connect your PC with Atari computer, you would have to build and use UNI-BI adapter - though if you are going to connect your computer with other PC machines only, you can.All terms on this page are trademarks of their respective holders.Powerful and fast (100 assembler).Command Parameter Meaning Port addr base address of parallel port (in hex!).EMS is not selling licenses to use any software on media for any purpose.Stavy sklad - zboí je skladem - zboí je na cest, zboí je objednáno u dodavatele a eká se na jeho dodání a naskladnní - zboí je na objednávku bez zálohy, zboí není skladem, ale lze jej objednat z jiné prodejny nebo u dodavatele.1.1 What is parcp?But do not try to run parcp Clients on both computers, that *might* be dangerous.CaseSensitive yesno if NO, upper and lower cases in filenames are considered to be the same.1.4.6 New features since last release The list of most important changes and features of new parcp version compared to previously released parcp.90: parcp-USB support bugfixes, bugfixes and once again, more bugfixes!
Parcp is freeware since June 2015 thus it's available completely for free.
When you start a function by F-key press, it acts on the actual file -.e.
Executes possible script file If a script file was defined (by -B command line parameter or by Autoexec directive idm dan key patch in parcp configuration file) and the file exists, it's opened and the commands in it are executed line by line.EXE into T (DOS) or StartUp folder (Windows95).In most modern IBM and compatible machines you can use the Bios setup (entered right after reboot by pressing the Del key, usually) for selecting the type of your parallel port.Example: Command What happens parcpcfg c:g it creates or updates configuration file named g PAR_IN c:g this turns the parallel port to input state parcp -f c:g and this finally starts the parcp with the right config file The configuration of parcp is done.Available everywhere and easy.